Yellow Secure Sleeve
Stand alone C19 secure sleeve - yellow.
Secure Sleeve
Red SecureSleeve
Red C19 secure sleeve applied to a blue cord.
C15 SecureSleeve
A black C15 secure sleeve installed on a yellow cord.
What Is SecureSleeve?
A flexible, tool-less sleeve that installs over the connector over-mold. By adding controlled interference at the mating interface, SecureSleeve increases removal force versus a standard friction fit—reducing nuisance disconnects while keeping serviceability fast.
Key Benefits
- Helps prevent accidental unplug events from vibration or strain
- Installs in seconds—no tools, clips, or latches required
- Low-profile; compatible with dense rack installations
- Repositionable and replaceable during maintenance
Color-Coding Power Paths
Available colors for at-a-glance redundancy management:
Yellow (A-feed) Red (B-feed) Black (neutral/general)
Use colors to standardize A/B feeds across racks and simplify troubleshooting.
Compatibility & Fitment
IEC 60320 Types
C13
C14
C15
C19
C20
- Designed for common over-molded cord connectors used in IT & industrial power
- Works with typical straight or angled over-molds (check clearance)
- Verify sleeve size against connector profile for optimal retention
When to Use
- High-vibration environments (fans, mobile carts, shop floors)
- Dense racks where cord movement can tug on connectors
- Where visual A/B feed differentiation is required
At-a-Glance Selection
| Connector Family | Typical Equipment | Recommended Sleeve | Notes |
|---|---|---|---|
| C13 ↔ C14 | Servers, switches, storage | SecureSleeve for C13 over-mold | Most common data-center pairing |
| C15 | PSUs, network equipment | SecureSleeve for C15 over-mold | Check clearances on angled plugs |
| C19 ↔ C20 | PDUs, blade chassis, UPS | SecureSleeve for C19 over-mold | Heavier cords benefit from added retention |
SecureSleeve increases removal force versus standard friction fit. Always ensure connectors are fully seated and meet equipment manufacturer requirements.
Install & Best Practices
Installation
- De-energize equipment when possible.
- Slide SecureSleeve over the connector over-mold; align flush to the mating face.
- Insert connector fully into the inlet/outlet until firmly in place.
- Verify strain relief and route cable to avoid tension on the connection.
Maintenance
- Inspect during quarterly checks; replace sleeves that are worn or deformed.
- Standardize colors (Yellow/Red/Black) for A/B feeds across all racks.
- Document locations in rack audit logs to aid remote hands.
Browse SecureSleeve Products
FAQ
What connectors does SecureSleeve support?
Typical fitments cover IEC 60320 C13/C14, C15/C16, and C19/C20 pairs. Verify sizing against your specific over-mold profile and any angled-plug clearances.
How much additional retention does it provide?
SecureSleeve increases the force required to remove a properly seated connector versus a standard friction fit. As equipment and connector tolerances vary, evaluate in your environment and document your findings.
Will it interfere with airflow or neighboring outlets?
The sleeve is low-profile and designed for dense rack layouts. Ensure there’s no contact with adjacent outlets or chassis features after installation.
Can I use color to mark A/B power paths?
Yes—Yellow, Red, and Black SecureSleeves enable quick, standardized visual identification of redundant feeds across racks.